工业控制 | 能源技术 | 汽车电子 | 通信网络 | 安防监控 | 智能电网 | 移动手持 | 无线技术 | 家用电器 | 数字广播 | 消费电子 | 应用软件 | 其他方案

电路设计->基础电路图->功率放大电路图->声音信号放大电路

声音信号放大电路

作者:dolphin时间:2012-07-30

电路能力测试-4:声音信号放大电路

Circuit Knowledge Test-4: Audio Buffer

2006年马槟厂设计工程师试题-4 - 爱碎碎念的老翁 - weng3309 的博客

  1. What will be the input and output impedance of QA4 stage with C2412 Hfe=100?

计算QA4的输入及输出阻抗。(假设电晶体的Hfe值为100)

  1. What will be the 6 db lower cut-off frequency and higher cut-off frequency?

计算本电路6 dB的低频及高频截止频率。

  1. What will be the audio buffer gain and maximum undistorted audio output RMS value with 5 volt DC supply?

计算本电路的基本放大倍数,及5V电源时的最大不失真电压值。

  1. Why audio buffer needs only one stage while video buffer needs two stages for amplification?

为何音频电路仅需要单级放大电路,而影像电路必须两级反向。

  1. Calculate the channel cross-talk for this circuit at 100 Hz frequency.

计算本电路在100 Hz时的左右声道串音比。

试题解答

Circuit Knowledge Test-4: Audio Buffer

ANS-1:

Input impedance of QA4: 4K7 and 6K8 and 560*100 in parallel. Actually 2K7.

Output impedance of QA4: 330 Ohm.

ANS-2:

Fl = 1/2ΠRC = 1/ (6.28 * 10u * 2K7) = 6 Hz while R = Input impedance, C = CA24.

Fh = 1/2ΠRC = 1/ (6.28 * 0.033u * 330) = 15 KHz while R = RA43, C = CA26.

ANS-3:

Audio buffer gain: RA43/RA49 = 330/560 = 0.6

Maximum undistorted output: 5.0/2.828 =1.75 Vrms.

ANS-4:

Audio signal is symmetric over dc balance line, while video signal is asymmetric with sync and peak white/black level. One transistor amplifier stage will give out reverse phase signal, then video signal has to reverse back to its original phase. However, audio signal also has to keep L/R channels the same phase.

ANS-5:

Channel cross-talk is caused by amplified signal feeding through dc supply line into the amplifier stage of the other channel.

Impedance of CA45 at 100 Hz: Zc = 1/2ΠFC = 1/(6.28 * 100 * 47u) = 33

Cross-talk rati Zc/RA43 = 0.1 (that is -20 db)



评论

技术专区