工业控制 | 能源技术 | 汽车电子 | 通信网络 | 安防监控 | 智能电网 | 移动手持 | 无线技术 | 家用电器 | 数字广播 | 消费电子 | 应用软件 | 其他方案

电路设计->电源电路图->其他电源电路图->ADM1278参考设计电路|电能监控器应用电路

ADM1278参考设计电路|电能监控器应用电路

作者:dolphin时间:2018-07-26

ADM1278是一款热插拔控制器,允许将电路板插入带电背板或从带电背板移除。 该器件还集成12位模数转换器(ADC),可通过PMBus™接口来进行电流、电压和功率回读。 负载电流利用内部电流检测放大器测量,通过HS+引脚和HS−引脚测量电源路径内检测电阻两端的电压。 默认电流限值设置为20 mV,如果需要,可通过内部基准电压源至ISET引脚的电阻分压器网络对该限值进行调整。

ADM1278特色及特点:

1、精度达到±0.3%,支持通过12位ADC进行 IOUT、VIN、VOUT和温度回读
2、短路响应时间:320 ns
3、检测到FET不良时关断
4、独立的热插拔和电源监控器输入允许附加外部ADC滤波
5、恒定功率折返支持更严密的FET SOA保护
6、远程温度检测,带有可编程警告和关断阈值

ADM1278经典应用:

1、服务器
2、电源监控和控制/功率预算
3、中央交换局设备
4、电信与数据通信设备

ADM1278典型应用:

图1:ADM1278典型应用

The GPO1/ALERT1/CONV and GPO2/ALERT2pins can beconfigured to indicate if a user defined threshold for voltage, current, or power is being exceeded. In this mode, the outputpin is live and is not latched when a warning threshold is exceeded. In effect, the pin acts as a digital comparator, wherethe threshold is set using the warning limit threshold commands.The ALERTx_CONFIG command is used, as for the SMBAlertconfiguration, to select the specific warning threshold to bemonitored. The GPO1/ALERT1/CONV or GPO2/ALERT2 pinthen indicates if the measured value is above or below thethreshold.

ADM1278中文数据手册:立即下载

更多源代码及源文件图下载:www.cirmall.com


关键词:

评论

技术专区